Appliance Error CodeDatabase
Bosch Oven error code

Bosch Oven E011 error code

Button / control input fault. Use these checks as a starting point, then verify the code in the manual for your exact model.

CodeE011
ApplianceOven
MeaningButton / control input fault

What the E011 code usually means

A control key may be stuck or receiving continuous input.

Model check: The same display code can have different meanings or procedures across product generations. Record the full model number before replacing parts or using a model-specific reset sequence.

What to check first

  1. Make sure the control area is clean and dry. Cycle power only after confirming there is no moisture around the controls.
  2. Inspect only user-accessible areas described in the owner manual.
  3. After correcting an obvious external issue, restart the appliance once and see whether the code returns.
  4. If the code returns immediately or the appliance shows heat, smoke, arcing, gas odour, or active leaking, stop using it and arrange service.
AdvertisementAdSense-ready placementResponsive ad unit placeholder

When to call a technician

Ovens involve high voltage and/or gas. Do not dismantle controls, igniters, or gas components unless qualified.

Professional service is also appropriate when the error returns after basic checks, when access requires removing fixed panels, or when the manufacturer documentation calls for electrical measurements or component replacement.

Related pages

Bosch Dishwasher E15Water in base / leak protection activeBosch Dishwasher E24Drainage problemFrigidaire Oven F10Runaway temperature detected
Primary verification path: confirm the code against the manual or support content for your exact model at Bosch Owner Support. This independent page is not a substitute for manufacturer service documentation.