Appliance Error CodeDatabase
Verified Samsung Washer code

Samsung Washer 8C error code

MEMS sensor issue. Start with safe external checks, then confirm the code against documentation for your exact model.

Manufacturer-source verifiedReviewed 2026-08-23Service may be needed
Code8C
ApplianceWasher
MeaningMEMS sensor issue

What this code means

The washer reports a vibration/MEMS sensor fault.

Model check: Code meanings and procedures can vary by model family and market. Record the full model number before ordering parts or following a model-specific reset sequence.

Safe checks to start with

  1. Power off and restart once. Repeated faults generally require service.
  2. Inspect only user-accessible areas described in the owner manual.
  3. After correcting an obvious external issue, restart the appliance once and see whether the code returns.
  4. If you see smoke, arcing, a burning smell, active leaking, gas odour or uncontrolled heating, stop using the appliance and isolate the relevant utility if safe.
Report a problem
AdvertisementAdSense-ready placementLoads only after publisher/CMP configuration.

DIY or technician?

Basic external checks only; use the exact model manual before removing panels or testing electrical components.

Repair-cost band: moderate. Actual cost depends on model, parts, access, labour and region. See the repair cost guide before booking work.

Related codes and symptoms

GE Washer 3Locked motor / motor faultHotpoint Washer F01Electronic circuit board faultHotpoint Washer F05Waste pipe blockage / drain faultLG Washer AERotation/gear errorLG Washer CLControl/child lockLG Washer dEDoor error
Primary verification source: Samsung Support. Last reviewed 2026-08-23. This independent summary is not a substitute for the exact model manual.