Appliance Error CodeDatabase
Verified Samsung Washer code

Samsung Washer 9E1 error code

Power error. Start with safe external checks, then confirm the code against documentation for your exact model.

Manufacturer-source verifiedReviewed 2026-08-23Stop/inspect promptly
Also shown as: 9E2, 9H1
Code9E1
ApplianceWasher
MeaningPower error

What this code means

The washer reports a power-supply fault.

Model check: Code meanings and procedures can vary by model family and market. Record the full model number before ordering parts or following a model-specific reset sequence.

Safe checks to start with

  1. Power-cycle once and verify the wall socket is operating normally.
  2. Inspect only user-accessible areas described in the owner manual.
  3. After correcting an obvious external issue, restart the appliance once and see whether the code returns.
  4. If you see smoke, arcing, a burning smell, active leaking, gas odour or uncontrolled heating, stop using the appliance and isolate the relevant utility if safe.
Report a problem
AdvertisementAdSense-ready placementLoads only after publisher/CMP configuration.

DIY or technician?

Basic external checks only; use the exact model manual before removing panels or testing electrical components.

Repair-cost band: higher. Actual cost depends on model, parts, access, labour and region. See the repair cost guide before booking work.

Related codes and symptoms

GE Washer 3Locked motor / motor faultHotpoint Washer F01Electronic circuit board faultHotpoint Washer F05Waste pipe blockage / drain faultLG Washer AERotation/gear errorLG Washer CLControl/child lockLG Washer dEDoor error
Primary verification source: Samsung Support. Last reviewed 2026-08-23. This independent summary is not a substitute for the exact model manual.